How to change a flat tyre safely: a step-by-step guide for the roadside

By the TripRank team · 10 November 2026 · 6 min read
Most drivers will face a flat tyre at some point. Changing one is straightforward, but the location matters as much as the technique. If you are on a busy highway, or you are unsure, calling roadside assistance is a perfectly good choice.
First, find a safe place
- Slow down gently, switch on the hazard lights and steer to a flat, firm surface well away from traffic.
- Avoid slopes, soft ground and bends. If the tyre is badly flat, driving a short distance on the rim to reach safety is better than stopping in the lane.
- Apply the handbrake, put the car in gear (or park) and have passengers wait well away from the road.
- Place a reflective triangle behind the car.
What you need
- A properly inflated spare, the jack and the wheel spanner.
- The locking wheel nut key, if your car has one.
- Gloves and a torch for night work.
Step by step
- Loosen the nuts slightly first while the wheel is still on the ground, turning anticlockwise. Do not remove them yet.
- Place the jack at the jacking point shown in your manual, then raise the car until the flat tyre is just off the ground.
- Remove the nuts and pull the wheel off. Keep the nuts together.
- Fit the spare onto the studs and hand-tighten the nuts.
- Lower the car until the tyre touches the ground, then tighten the nuts in a star (criss-cross) pattern.
- Lower fully, remove the jack and give the nuts a final tighten.
Afterwards
- Check the spare's pressure as soon as you can. See the tyre pressure guide.
- A compact spare has speed and distance limits. Drive gently and get the damaged tyre repaired or replaced.
- Re-check the nut tightness after the first few kilometres.
Be ready before it happens
Check the spare's pressure with your regular tyre checks, and find the jack and spanner once, in daylight at home. Include these in your road trip checklist. If you record a trip with TripRank, your location history makes it easy to describe where you broke down.
Frequently asked questions
Where should I place the jack?
Use the jacking point shown in the car's manual, usually a reinforced spot on the frame near the wheel. Using the wrong place can damage the car or make it unstable.
Why loosen the nuts before lifting the car?
While the wheel is on the ground it cannot spin, so the nuts are much easier to break loose.
How fast can I drive on a spare wheel?
A temporary or compact spare usually has a speed and distance limit marked on it, so check and drive gently until you can replace it.
Should I change a tyre on the highway?
Only if you can reach a safe, flat place well off the road. Otherwise call roadside assistance.
Car speedometer app: how to pick an accurate GPS speed app (and what to avoid)
Car acceleration app: how to measure 0 to 100 km/h with your phone (safely)